When the end of a freshly taken cutting is dipped into the Gel it seals the cut-end and the rooting hormone encourages root-shoots to form. Used as part of your propagation process, Clonex Rooting Gel will significantly increase your success rate and reduce the time it takes for cuttings to take root.
How long does Clonex take to work?
It may take 3 months to establish an extensive root system and once this happens then you can re pot into a larger pot. Take more cuttings than you need as not all cuttings will strike. It may take up to 18 months before the cuttings are ready to be planted into the garden.
What does Clonex rooting gel do?
Clonex Rooting Gel is a high performance, water-based, rooting gel developed by Growth Technology™ Ltd. It is a tenacious gel which will remain in contact around the stem, actually sealing the cut tissue and then supplying the hormones needed to promote root cell development.
How much Clonex do I need?
Directions for General Use – Shake well before using! For general use, dilute at a rate of 10ml (2 teaspoons) Clonex® Clone Solution per 1 liter (1 quart) of water or 2 1/2 tablespoons per gallon. After mixing, adjust pH to appropriate level (5.5 to 6.5). Soak rooting media.
Is Clonex good for seedlings?
Clonex® Clone Solution is a plant nutrient specifically formulated for rooted clones and seedlings. It contains a special blend of the highest quality minerals including Nitrogen, Phosphorus, Potassium, and Calcium plus other essential elements that all plants require for root development and vigorous growth.
How quickly does root gel work?
Depending on the rooting hormone product, rooting occurs usually after 2 to 8 weeks. Before this rooting period is over it usually isn’t necessary to water plants as often as they would normally need during the rooting stage under normal conditions.
Can I mix Clonex gel with water?
Dip all your cuttings in Clonex gel as normal. Put the cuttings in the cloner and mist with Clonex mist or water to keep them hydrated. Wait 20 minutes to allow gel the adhere to the tip of the cutting and then turn on the cloner. When roots appear, water with Clonex Clone Solution at the normal rate.
When should I use Clonex?
Clonex Rooting Gel is used at the beginning of propagation to help seal your cuttings delicate root tissue and provide the necessary environment for successful rooting. Clonex Clone Solution is specifically formulated for rooted clones and seedlings.
Does Clonex gel expire?
Once opened, how long will Clonex gel remain effective? Clonex gel is guaranteed for two years but, the effectiveness will be shortened if best practices are not followed.
Does Clonex raise pH?
Answer: Clonex Clone Solution buffers most water so that the final pH is in a suitable range for plant growth (5.5-6.5). You will mostly likely need pH adjustment solutions if you have hard water. General Hydroponics and Bluelab are two companies that make pH adjustment solutions.
Can you mix Clonex with water?
Mix 5ml – 10ml of Clonex Clone Solution per liter of water (one or two teaspoons per quart). After mixing, adjust pH to appropriate level (5.5 to 6.5). Finally, soak medium for several hours or add to Aeroponic system. Allow for adequate drainage to avoid water logging.
Is rooting hormone safe?
Although auxins are produced naturally, most commercial products contain auxins made in labs. These products are deemed safe when used in small amounts, but organic gardeners often prefer to avoid chemicals in the garden. Instead, they opt for propagating plants with organic rooting hormone such as a vinegar solution.
