Press SELECT and the pager will display the choice. Scan the 10 MUSIC melodies and 4 beep alerts by pressing MODE. Choose the alert by pressing . Press MODE until SET ALERT? is displayed.

How do I delete all messages on Apollo pager?

display ” MESSAGE DELETE ” Mode. displayed on the screen , press to delete the message. DELETE ALL ” Mode . displayed , Press , all unlocked and read messages are deleted.

How do you repair Apollo pager?

To reset your pager:

  1. Take the battery out.
  2. Put the battery back in THE OTHER WAY ROUND.
  3. Leave the reversed battery in for approximately 5 seconds.
  4. Remove the battery.
  5. Put the battery back in THE RIGHT WAY ROUND.
  6. Switch the pager on again. You should now hear a ‘beep’.

How do you turn a pager on?

Press and hold for 2 seconds to turn on the pager. Press button once from the Main Menu screen to go to the Function Menu screen, then press button five times to select TURN OFF function. Press button, “TURN OFF” is displayed. Press button again to confirm turning your pager off, or button to cancel.

How do I clear my American message pager?

To Delete a Single Message O From the Message-Status screen, press or to select the message you want to delete. 2 Press Press to move the cursor to a 4 Press O DELETE MESSAGE? is displayed. 6 Press • again to delete the message.

How do I silence my pager?

How do you unmute a pager?

To switch your pager OFF, first press and hold the MUTE button and then press and hold the OCR button. The pager will sequence to “OFF” and then switch itself off after approximately 2 seconds. If either, or both, buttons are released and repressed, the timeout sequence will continue.

Can I reactivate my old pager?

your pager can be activated with local, regional or full regional coverage but not nationwide coverage. if your pager is on frequency 929.6625, it can be activated with nationwide coverage only. If it’s on frequency 929.9375, it can be activated with local, regional or nationwide coverage.

How do you program a Minitor pager?

The first thing to do is place the pager into programming mode.

  1. Insert a good battery into the Minitor V pager and turn the pager off.
  2. Change the switch position to “C”
  3. Hold down the reset button then turn the pager on while holding the button down.
  4. Release the reset switch.
  5. The Minitor V pager is now in programming mode.